Overall Length | 34.01ft in |
---|---|
Clearance | 1.28ft in |
Front Tyre To Rear Bumper | 29.52ft in |
Height: Low Profile Cab | 10.5ft in |
Maximum Steering Range | 49degrees |
Minimum Turning Radius | 23.96ft in |
Ripper Beam Width | 7.57ft in |
Steering Articulation Angle | 25degrees |
Tandem Wheelbase | 5ft in |
Track Gauge | 6.76ft in |
Width Of Moldboard (Optional) | 14.18ft in |
Width Of Moldboard (Standard) | 12.18ft in |
Width Of Tyres | 8.17ft in |
Side Wall Thickness: Inner | 0.1ft in |
Side Wall Thickness: Outer | 0.1ft in |
Wheel Axle Spacing | 5.1ft in |
Tandem Oscillation | 11° forward, 13 ° reverse |
Drawbar Frame | 210 x 25 mm |
Ripper Penetration Force | 19288.7lb |
Ripper Pry Out Force | 28685.7lb |
Number Of Cylinders | 6 |
Piston Displacement | 408.3cu in |
Engine Model | KOMATSU SAA6D107E-1 |
Front Frame Structure - Height | 1ft in |
Front Frame Structure - Width | 1ft in |
Engine Type | Water-cooled, 4-cycle, direct injection |
Net Power | 193.2hp |
Gross Power | 195.8hp |
Air Cleaner | 2-stage, dry-type |
Max Torque | 649.1lb ft |
Battery | 2, low maintenance plus, 12 volt, 1146 cca |
Fan Speed | Max. 1500 rpm |
Electrical | 24 volt with 90 amp alternator |
Torque Rise | 29% |
Bore | 4.3in |
Stroke | 4.9in |
Aspiration | Turbocharged and air to air aftercooled |
Fuel Tank - Diesel | 109.9gal |
Cooling System | 6.6gal |
Transmission | 11.9gal |
Final Drive | 4.5gal |
Tandem Housing | 15.1gal |
Hydraulic System | 18.3gal |
Circle Reverse Housing | 1.9gal |
Crankcase | 6.2gal |
Blade Down Pressure | 19330.2lb |
Blade Pull | 25159.2lb |
Total Operating Weight | 39947.8lb |
Wheel Lean | 20degrees |
Oscillation - Total | 32degrees |
Ground Clearance | 2.1ft in |
Front Axle Type | Solid bar construction welded steel sections |
Moldboard Side Shift Right | 2.7ft in |
Standby Pressure | 500psi |
Moldboard Side Shift Left | 2.7ft in |
Maximum System Pressure | 3000psi |
Output | 52.9gal/min |
Maximum Lift Above Ground | 1.6ft in |
Maximum Cutting Depth | 2.1ft in |
Maximum Blade Angle | 90degrees |
Blade Tip Angle | 40 ° forward, 5 ° backward |
Circle Center Shift Right | 2ft in |
Circle Center Shift Left | 1.9ft in |
Blade Length | 12.2ft in |
Moldboard Width | 12.2ft in |
Moldboard Height | 25.4in |
Moldboard Thickness | 0.9in |
Cutting Edge | 152 x 16 mm |
Arc Radius | 1.1ft in |
Diameter | 60.3in |