| Overall Length | 47.25ft in |
|---|---|
| Overall Height | 22.58ft in |
| Wheelbase | 20.84ft in |
| Turning Radius | 46.59ft in |
| Width Over Tires-Front | 22.51ft in |
| Width Over Tires-Rear | 23.92ft in |
| Ratio | 31.875:1 |
| Control | AC Torque Control System |
| Motorised Wheels | GEB25 |
| Maximum Speed (Km/H) | 64 |
| Alternator | 24 volt, 140 amp |
| Lighting | 24 volt |
| Cranking Motors | Two/24 volt |
| Capacity - Struck | 153.1yd3 |
| Heaped (2:1, Sae) | 192.3yd3 |
| Payload | 488650.2lb |
| Structure | Flat floor configuration |
| Canopy Sheet | 5 mm 0.19'' 690 mPa 100,000 psi |
| Front Sheet | 12 mm 0.47'' 1379 mPa 200,000 psi tensile strength steel |
| Side Sheet | 8 mm 0.31'' 1379 MPa 200,000 psi tensile strength steel |
| Floor Sheet | 19 mm 0.75'' 1379 mPa 200,000 psi tensile strength steel (two-piece) |
| Number Of Cylinders | 16 |
| Engine Make | 2238 |
| Engine Model | SDA16V160 |
| Power Measured @ | 1900rpm |
| Displacement | 3661.5cu in |
| Fuel Type | diesel |
| Weight | 21182.1lb |
| Horse Power: Sae J1995 | 2501.1hp |
| Operating Cycle | 4-cycle |
| Service Brake Type | all-hydraulic actuated |
| Parking Brake Type | Spring-applied, hydraulically released, with speed application protection. |
| Front | Wheel speed disc. Three calipers on a 1213 mm / 47.75' O.D. disc |
| Rear | Dual disc armature speed. Two 635 mm / 25' O.D. discs per side. One caliper per disc. |
| Emergency Brakes | Automatically applied prior to hydraulic system pressure dropping below level required to meet secondary stopping requirements. |
| Wheel Brake Locks | Switch-activated |
| Electric Dynamic Retarder (Max.) | 2983kW Continuously rated high-density blown grids w/retard at engine idle and reverse propulsion. |
| Fuel Tank | 831.1gal |
| Cooling System | 116.5gal |
| Hydraulic System | 210.1gal |
| Crankcase | 59gal |
| Motor Gear Box | 10.1gal |
| Gross Weight | 850649.2lb |
| Empty Weight | 361999.1lb |
| Standard Tire | 40.00R57 |
| Hoist Cylinder | Two 3-stage dual-acting outbound cylinders and internal cushion valve, over-centre damping. |
| Relief Pressure | Hoist-17240 kPa 2,500 psi, Steering and brake-27580 kPa 4,000 psi |
| Hoist Time | Power-up loaded: 21 sec, Power-down: 16 sec, Float-down empty: 17 sec |
| Turning Circle Diameter (Sae) | 93ft in |
| Reservoir | 238gal |
| Filtration | In-line replaceable elements |
| Suction | Single, full flow, 100 mesh |
| Hoist And Steering | Dual, in-line, high pressure |
| Pumps | Tandem gear-type pump |
